Search results

Yes that is the part# pdq

Anyone know where to obtain dryer belts best deal pdq 11075 3v is the part number. Need 2. Thanks in advance

Printer back on. J2 found jumper wire loose and bad relay. Thanks much for the lead. Working now.

2troubles I am having with my 4000. Printer wont print even though the power light is on to give a fault code. The fault I have is the entrance door will not open when money is put in at pay station. You can manually open and close, the exit door works fine no issue. There is 80 psi to the box...

wolfe Finally found trouble,a relay had failed on the board, sent panel to Ginsan in G Rapids for repair, works like new. Sometimes you need a little help. Thanks for the input.

Timer does rack correct time, plugs are plugged in timer, will check validator and board out, thanks for the tips..

Yes bill accepter in door..

Yes gs 400, no countdown nothing will operate with any button.

Have self serve touch tron panel, Ginsan equipment, gs200 timer 4 years old. When money is put in the timer buzzes and no function switch will work, timer light is on and flickers slightly. Bad timer?? Reset with mode button and it clears, put money in it buzzes same thing..anybody??

OK so here is my answer, 30 prox is receiving interferance, even though the festoon cable is fairly new, 50 ft of 18 ga 3 wire, from 30 prox down festoon to jo should cure the issue.

Have a PDQ 4000 with virtual treadle, length measures ok, wont measure width correct ,wide drivers side, foam arch rides passenger side slamming mirrors, took out 1 shear bolt. Does not seem consistent with width measures..No trouble code at JO panel. Thanks for the info.

Have a site with 340 cat pumps direct drive. These are older pumps, they have been well maintained. I replaced hi pressure seals pistons lo pressure seals and also installed nw seats that seem to get pounded from leaking. My question is I still have lo pressure 900psi at the gauge. Nothing is...

Randy We are in Northern Michigan, I agree Iintend to crank down the timer, thanks guys

Anybody raise there prices since the cost of inaproppriate fuel hikes, as cost of doing business rises, how in the heck are we going to stay open for 2 bucks for 4 minutes? Is three dollars for 4 minutes out of the question ? It seems as though we find ourselves doing this at almost cost..

The trolley cant do its job if it is not recieving signal replace the festoon cables solve your troubles..

Where is the best place to purchase signage? TSS? Pretty pricey. Got a quote from an independent sign company, wow, wrong. Any one.. In need of menu & peak signs built.

Wolfe I do have 1 location with the virtual treadle and like you dont have any trouble, this is an older site but I am upgrading as I go..

wolfe Ok found the troble to be in the treadle, the bushings were worn just enough to cause the treadle to move far enough away from the prox. Replaced the bushings and rubbers, adjusted the proxes closer to the tabs, no trouble since. It is difficult sometimes to isolate issues but I knew it...

I have 5$ 7$ 8$ washes, the 7$ & 8$ wash only have underbody. My counts show on the tape 5$ & 8$ washes are operating the customers that have been calling in are the 7$ washes. I just replaced treadle rubbers, thinking sensitivity on the proxes were the trouble, also double checked connections @...

Laser 4000 (with treadle) on the 7$ wash customer can enter but then nothing happens. Treadle bushings are tight JO panel shows time exceeded. When I go over it works perfect. Prox switches seem to be operating ok as well any guesses out there?? I hate reimbursing people.