Search results

I think you can trace the dip switches back to the computer to see what they are wired into. Had one quite awhile back and I think you could wire them into any of your options such as wax, tilt any thing that is a option. hope this helps.

Because you were on vacation. Stay home and these problems magically disappear.

Thanks for the info I just ordered one. Then just got my grainger book and they now show them also.

Looking for miniaure time delay relays that are 24 volt. All that I have found are 120 volts. Any ideas?

Are these prices including equipment or are they building only?

Wondering if anyone has built a new wash 5 self-serve 2 automatics lately. Just wondering what the cost to build was. I have been getting bids and they still seem pretty high.

Sounds Like you have ice on the track. Mine has done this if a cold wind comes through and freezes the track.

card reader I have Washcard and have never had to replace a reader except 1 that was destroyed by a crowbar. If they quit usually just wet. Remove power wash out then blow dry with air. Good luck Bill.

When doing floor heat are you insulating under slab first? Mine have always been without insulation but been talking to a builder and they say it should be insulated.

Trying to get ideas on current cost to build a 5 self-serve 2autos. Looking for construction costs only. Also where are you located? I know cost vary by area. Thanks Bill

How many are you looking for? I think I still have some up in storage. Bill

I used polymax panels from farmtek. I used 2 X 10 by 1/4". Make sure to allow for expansion and shrinkage from tempature.

Acw I had a ACW along time ago and it had a wierd problem kinda like yours. It ended up being behind where all the relays are, it is soldered with hard bare wires. the thing would heat up and the wires were close enough to each other that they would heat up and touch each other. Good Luck.

I'm looking into a ics Wash Valet. Does anyone have one if so How do you like it? Also Unitec Wash select II, or Portal. How do you like them? Thanks Bill.

Those are the good ones they take the bigger size coins. I'm assuming that your tokens are a little bigger than a quarter more like a dollar coin size.

One thing to check is make sure your hoppers are the red labeled ones to do the tokens if the tokens are bigger than a quarter. I think it says the dimensions of the coins that the hoppers will accept in the red writing. Good Luck Bill

I am looking at the quicksilver for a new wash. Do people run hot water at high pressure or just hot presoak. Also see some comments on here about speed. How fast on what type of car and what options picked. Also is your dryer onboard or stand alone, if stand alone what brand of dryer?

They are 3/16" 2'X10' Panels.

Going to build a new wash. Have been curious about the vfd systems. How have they worked out compared to regular systems? Thanks

Looking to build a new wash. Which paystations have you used? What good or bad things about your paystation. ICS? American Paystation? Wash Select? Hamilton? Thanks