Search results

Hi all, thank you very much for all your help, my system is now up and running. Thank you again Tom for your detailed information.

Thank you for your help Tom. I will verify the wire connection again and let you know.

Hi Tom, on VDF(VLT2-Oscillating) to out put card, I have a grey wire go from VDF S1 to output card pin 4 (oscillating motors). On low pressure tests, the Pre Soak, Spot free rinse and Low PH Pre Soak are working correctly with (spray water) and oscillating the output cars pin 4 LED is turn on...

Still failed with new connector installed.

I think I might find the problem why it won't oscillate on HP wash, found the HP hose broke loose on one side (customer side) of the oscillator. will find out after I get the new connector.

Hi all, I have been working on my auto wash with all wires are reconnected and still run into some problems. The following tests have been perform: Manual switch test on Gantry and walk through all functions are working good. Did the Screen Test from computer (ECP) with the following errors...

Thank you Waxman

Sure will do and thank you

Thank you again Tom, received copies of your schematic today, with these schematics I've more confident to connect those wires back together. Hoping that there won't be many components will be failed. Thank you very much for your help.

Thank you for the advise John.

Tom, Thank you very much for sending me those wiring pictures. Hopefully I can figure out where those wires go and will post update. It will be very very tough. I am not sure I can do it but I will give it a try first.

Hello all, I have gone through the WW 1.0 manual but still have very hard time to figure out where all wires go to. Anyone that has WW 1.0, please help me by taking picture of inside your Gantry Control Panel (wiring), hoping between both the wiring and manual will help me better figure out...

Thank you very much John, I will study and hope I can figure it out.

Hi Tom, I could not send an email to Greg. Please help sending your copy of wiring schematic. I have PM you my mailing address. Thank you Tom

Hi Greg, not sure what wrong but your mail box was not accepting my email. I received the message below. Sorry, we were unable to deliver your message to the following address. <almohle@colemanhanna.com>: 550: 5.1.1 <almohle@colemanhanna.com>: Recipient address rejected: User unknown

Hi Greg, I have just sent you a request to the email above. Thank you very much.

Thank you very much Tom, I just saw the message from Greg Pack and I did send him a request. Thanks

Hi Tom, I have been called Colman everyday and the receptionist transfer me to Colman Tech support but alway to voice mail. I left many messages but never get any response back. Would you please share a copy of your wire schematic for me. I'm willing to share the cost with you. Thank you very...

Thank you Tom and I really appreciate your offer, no one calling me back from Coleman yet, I will call Coleman again tomorrow and hope I will get some response. I will let you know if I can get any help from Coleman. Thanks