Search results

If budget allows and neighborhood won't trash them I would get all Coleman Combos with Vault Bases, Bill acceptors and Credit Card with count up. The Shampoo vacs did better because Shampoo cost more than fragrance and people have to vacuum u the shampoo. Think of this way. Will the combo...

Try increasing motor pulley size on pump by 1". That is what I did - same pump.

Make sure when replacing ring is between upper ring in vac and lower partial rings. Had a dingbat not do this and dirt got past bags

That is why the FB is continualy flushed with soapy water and Instructions say to rinse brush with HP before using.

I added CC to half the bays with Cryptopay and put up signs saying "These bays accept Credit Cards" Did count up. In short order I was conviced to do the rest and then the vacuums. I already had LED 7 Timers in the bays.

Had this happen and found a wire contacting the box

It is all about perception. Whether tunnel or SS Nylon is as gentle as can be if lubricated properly. It's softer than a toothbrush (Which many detailers use on painted surfaces. to get in nooks and crannies) but requires continua; flushing of debris and lubrication.

But you have people you trust to make sure everything is running properly and fix what isn't?

There are Federal reporting requirements for cash deposits over $10,000. Unless you need to deposit in excess of this amount every day, it is better to make smaller deposits .

On outside white brick of the SS I went with a Concrete stain from home depot. . Goes on like paint but gets absorbed into the brick - doesn;t just sit on top. Don't paint inside of bays. recommend pebble finish FRP.

After all this time you don't like that acceptor or are you switching to tokens or dollar coins?

Amazing he still has that Paraplate model in Service . I have some but I think they re all 24V Operation.

Wobblehead seemed the same if not identical except it worked with the low pressure . There was a small piston inside where the handle met the head. Itwas spring loaded. The pressure made the Piston move forward into the flexible part making it rigid. I think I gave up on the second Generation...

The liquid levels in my tanks that feed the Pumps is above the highest pump on 2 high stack. I know pumps can draw up but wonder if the liquid supply level is lower than the tank if it is less efficient.

That was why I liked the Wobblehead handles. Reduced people trying to use FB as a Brush for the Pickup beds. Sadly the later generation of Wobblehead handles did not last long so I stopped using them.

I have mounted to the side of Super Vac 3 on the side opposite the door. I just drilled Holes thru the Vac and bolted the Machin to the Vacuum. Used Large Washers inside the Vac. Had these for decades. I ran a separate power line to these. So I used the unit's coin mech / timer. Ithink...

Gave up on Summer Breeze and Purple passion from KR due to gelling issues . I now use the KR low PH Product. The small tip size on a HP gun cannot provide foam like a Foam Brush. I get this out of the HP gun for wheel and tire and about same can be done with PS but you need to turn liquid...

I have successfully used silicone sealer and Flex tape to seal the partition on my D & S SS tanks. It's an inexpensive experiment.

I use an old car antennae.

Came across some interesting threads Videos vis a vis Shark Bite Vs Competing Brands. One was "Quick Connect. Supposedly Shark Bite failed at 750PSI and Quick Connect at 300o psi or something like that. Also see "Watts" at Menards. Found Watts interesting because they have a poly /...