Danfoss Drives

[Tom Thumb]

If anyone has any Danfoss Drives (176F7301 ) for WW 1.0 I would be interesting in purchasing. Not happy with the newer versions.

Contact:

ctbfl@cfl.rr.com

321-624-2684

 

[washnvac]

Is this the newer model you have: Danfoss 132F0010 ? I replaced all the 176fs with these and have had no issues.

 

[Tom Thumb]

Yes
Unable to get any help on programming or wiring
From danfoss or coleman.
Coleman suggest using yaskawa from them at 3 to 4 times the cost.
176f are easy to install and program

 

[Greg Pack]

yaskawas are fairly cheap- around $200 if bought online IIRC

 

[Tom Thumb]

Ordered one from Coleman to get instructions for wiring and parameters.
Only $425.65 .will get online next time.

 

[Tom Thumb]

Washvac
Do you have information on wiring and programming on the 132F0010 vs the 176F danfoss?

If possible I would like get it so I can change mine , as I have 2 new dansoss drives in eq. room now.

Thanks for any help .

Tom Thumb

 

[washnvac]

I will grab the info next time I am at that wash. It will be mid to end of week. I have to look at wire and try to remember what was different. The programming was fairly easy; I just went through the manual checking each parameter--man there is a mess of them. The only issue I had was getting the slow speed on the drive motors. But I finally found it by playing around. PM me your e-mail, and I will send you what I have.

 

[fillupc]

I am also trying to switch over to the newer Danfoss drives (132F0010). Would anyone be willing to share the wiring and programming information for WW1?

Phillip