What's new

pecial Tips on Hydrominders for Concentrates

washregal

Member
Joined
Sep 11, 2007
Messages
410
Reaction score
13
Points
18
Location
Pennsylvania
Ok..

Looking at concentrated chemicals I get it.. Don't need to buy as much product for it to last longer.. However.. I still need to mix the product with water in my equipement rooms.

Theoretically isn't that what we are doing with the Hydrominder?

Is there a special tip that is available other than standard 511 tips that will cut consumption so that we do not need to cut the chemical with water?

Just looking at consolidation of floor space and spillage issues. Just cut my triple foam.. am a a colored monster.. a real mess.
 

MEP001

Well-known member
Joined
Aug 30, 2007
Messages
16,665
Reaction score
3,946
Points
113
Location
Texas
There are ultra-lean kits you can use, which basically dilute it twice as it draws straight from the concentrate.
 

Wally

Member
Joined
Sep 9, 2007
Messages
176
Reaction score
0
Points
16
Location
Buford, GA
I`ve used the ultra lean tips without diluting the product. The problem was keeping the tiny hole unclogged. They are really small. I`m not talking about trash in the product. Dilute it and go with the smaller diameter tips and hose. If you will get rid of that half inch hose in the product you will be a lot happier.
 

JMMUSTANG

car wash owner
Joined
Sep 1, 2007
Messages
1,288
Reaction score
198
Points
63
Location
at the car wash
Mike at Kleenrite talked me into trying vanilla cream hp soap years ago.
He didn't tell me to dilute it, he just told me to use the smallest tip.
When I got it I changed the tip, put the hose into the 5 gal. bucket.
The next day I got there I had thick soap all over the cars & bays and these HUGE soap bubbles floating in the air. The customers loved it.
I called Mike a couple of days later to tell him about all the soap and bubbles.
That's when he asked me if I read the directions. I didn't have my glasses with me. Oops.
The tip didn't clogged but I went ahead and mixed it right.
I just wonder what would have happened if I left it alone.
 

Mr.Aap

Member
Joined
Sep 2, 2007
Messages
132
Reaction score
0
Points
16
What is the dilution ratio of the product......
 

Randy

Well-known member
Joined
Sep 5, 2007
Messages
5,861
Reaction score
2,224
Points
113
I use Kleen-rite Vanilla Cream soap for both the High pressure soap and Foam brush soap. It works great, lots of suds and it smells good, seems to clean well. I mix it with 10 gallons of water to a 5 gallon pail of soap, like the directions on the side of the container tell you to. I use a Turtle wax dual tip metering block on the Hydrominder, this cuts it down even further.
 
Top