toddmullens
Active member
Does anyone have a water wizard with two step low pressure presoak? I am trying to figure out how its plumbed and if I can convert a machine to using a low pressure high alkaline presoak and low pressure low ph presoak.
Car Wash Forum
This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
Water Wizard 2.0 2-Step Presoak
- Thread starter toddmullens
- Start date
I have one. They run out separate lines to just above the drivers side of the gantry. At that point the two lines tee in and run to the presoak solenoid in the below pressure cabinet. It works but it takes about eight seconds to purge the previous product properly. You can account for this by having a start delay of ten seconds on the two presoak passes.
toddmullens
Active member
I assume each line has a check valve where they T together?
Actually they don't. There is normally a check valve on the discharge side of each presoak pump. However, I like your idea better. Coleman uses the black SMC check valves and they are economical and work OK. However it seems sooner or later they crack at the threads. I use the stainless steel teflon check valves made by fluid controls to replace them when they do.
Todd, I will add that even though the cat presoak booster pumps are awesome and work for years without issue, this is a good opportunity to buy and use a multi stage booster pump and injector for your second pass for almost the same amount of money. This would allow you to convert to injector-based system in the future without too much expense, if that sort of thing has an appeal to you.
toddmullens
Active member
T
This site is one of the newer setups already using the injectors. I am wondering why they didn’t use a 3 phase booster pump on these instead of the single phase. I have already replaced both the pumps on both u its and had to replace the capacitors on both motors as well. I am thinking about switching it out to a 3 phase and installing an overload on the motor starter. Any pros or cons that you are aware of in replacing the booster pump with a 3 phase version?
This site is one of the newer setups already using the injectors. I am wondering why they didn’t use a 3 phase booster pump on these instead of the single phase. I have already replaced both the pumps on both u its and had to replace the capacitors on both motors as well. I am thinking about switching it out to a 3 phase and installing an overload on the motor starter. Any pros or cons that you are aware of in replacing the booster pump with a 3 phase version?
toddmullens
Active member
I assume both functions use the same air solenoid?
