What's new
Car Wash Forum

This is a sample guest message. Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!

water wizzard leaking pump stand compartments

earthwash

New member
Recently my soap compartment is leaking into my wax compartment on my pump stand on my Water Wizzard (Coleman).
These compartments are stainless steel and the welds have failed. I have had to drain them, sand the seams and seal with marine 5200 by 3m. A better solution would be Plastic tank compartment inserts. Is there anyone who has a source for plastic inserts.
 
Another option is to remove the entire chemical mixing tanks, mount a board and then attach injectors. You can use one of the big chemical pumps to feed the injectors if you pressure feed the pump to get the needed 200 PSI to supply the injectors. I haven't done this, but I know a guy that did this on a few sites.
 
Why reinvent the wheel? Just remove the tank and take it to a welding shop and have them grind the old welds off and re-weld with stainless welding wire. When you own a car wash, especially automated machinery, you often need to have parts welded. Heck, I'm dropping off a hunk of spray bar assembly at my welder's today!!! :cool:
 
Recently my soap compartment is leaking into my wax compartment on my pump stand on my Water Wizzard (Coleman).
These compartments are stainless steel and the welds have failed. I have had to drain them, sand the seams and seal with marine 5200 by 3m. A better solution would be Plastic tank compartment inserts. Is there anyone who has a source for plastic inserts.


I have a bare tank stand from a water wizard sitting at my warehouse not being used if your interested I would make you a deal on it PM me if your interested
 
Not impressed with Coleman's welds (on their tanks or their equipment).
Every one of my Coleman vacs have had welds fail over the years and begin to lose suction. Sometimes bad enough to scrap the whole vac when I can't gain access to repair it. I've never seen that on any other vacs.
 
Every one of my Coleman vacs have had welds fail over the years and begin to lose suction. Sometimes bad enough to scrap the whole vac when I can't gain access to repair it. I've never seen that on any other vacs.

That's the issue we ran into with the tanks. My whole family is pretty talented using a welder, but if you can't get at the welds it doesn't do you any good. I honestly can't believe how crappy some of the welds are coming out of their factory. One tank failed in less than a month (although that one we got replaced at no charge).

Knock on wood, no problems with our vacs yet. But we have done several modifications to stiffen/strengthen parts of our WW's where we felt the factory welds were not acceptable.
 
i just turned it into a water supply and put a dosatron down stream on both tanks (that way it doesn't matter if they cross over.)
 
Back
Top