Search results

Yes they are all plumbed in the right direction, upon I selection of plunger heads they all seem good.

Yes I'm seeing soap in bays. https://www.kleen-ritecorp.com/p-1849-kip-solenoids-14-24-v-metering-side-orifice-18.aspx

It's only 3 bays and I Havnt had it happen enough times to figure out exactly which one it was. That is my fault Im smart enough to know better and to check for a more specific problem.

They are individual, the description in the catolog SPECIFICALLY recommends these solenoids for pre soak chemicals, and they are only a month or so old to boot! Every time I check them I find nothing and they move freely. Could it be electrical? Even though I always check with my voltmeter and...

Took them back out and checked to find nothing, lowered flojet to 55psi. Just can't imagine that a solenoid specifically sold for pre soak chemicals up to 150psi barely works at 60psi. Guess we will see how it holds

Hey guys I'm having trouble with my presoak system. I just completely updated with a new flojet kalrez pump, new kip solenoids specifically rated for presoak, fresh plumbing. I had it running for a few months with no problems whatsoever @83psi to the flojet(rated up to 90psi) and the solenoids...

tada!!

My hydro under stuck open not to long ago. Good thing I caught it quick enough

My thoughts exactly!!

Yes good point, can you give me an example of a relay you would recommend?

No I haven't had any problems that I can recall. I just know my luck!

About 10gpm right?

Do you have any pictures? I think I understand for the most part but I need to see it with my own eyes.

Yes I know but I want a solenoid to go in front of the flo jet to prevent dumping of chemical. So that one solenoid will need to be wired in with all the other ones so anytime one solenoid turns on, so does it

Rhythm isn't consistent. It goes up and down

So how would you wire all the solenoids into one before the pump to eliminate that?

Can you explain what you mean by "dead heading" and how to hook them up?

Recommended is 65psi. I tried going higher and lower with the pressures and nothing helped.

My automatic trolley isn't producing a good amount of presoak. It spits and sputters air with some presoak, more comes out the bottom of trolley. It is powered by a yamada diaphragm pump.

Great explanation thank you! I plan on making a new mounting board and getting rid of all that old junk!