Search results

check the 2 little o rings and Teflon back ring on the crome shafts, use silicon o ring lube when siding crome sleeves on so they won't get nicked. water is pushing past o rings.

ica and local shows are we buy equipment and lots of it, any ware but Chicago, will miss show first time in 20 years. any body who goes to chicago have at it.

found factory assembled problems in lose ground wires, found cause for a $ $800 board failure, a wire that dislodge itself and poped out of factory assembled connector that controls shampoo head, some connectors were pull and plug ( about 12 connectors) on board, others were very hard to...

adams response was go to hell

when trying to trouble shoot, found information provided by adams to be poorly presented, schematic provided is useless and income pleat , trouble shooting guide is useless, some information was generic in nature. plastic nuts on hoses very weak, fuses holders on vacs break when vac motors go...

surprised on how easy it is to damage a adams combo vacuum. some one pulled on the shampoo hose while it was on the hanger. resulting damage occurred when the hose pulled out of the shampoo head, which is held in by a weak plastic connector. pulled control wires and supply hoses out of unit...

quite a few years ago we moved all meters to out side of bay meter is fully enclosed in block work, was expensive, but now our maintance has dropped to a very low level and we also have bill acceptors installed. water damage is no longer a problem.

make sure you can buy replacement parts like lens, like a glass lens,. . Lithonia is a brand we have bought. any light that spares are not supported are not worth the cost or problems. Once led die its nice to know that is easy to repair. Also failure mode for a led is a short, not a open. We...

led replacement am in the same boat our led 250 hw are old, it was easy to just buy some led 60 leds new fixtures then it was to update housing, its not only the cost but also dealing with old housings dirty lens old gaskets and we repositioned some lights . new lights were easy to install...

we have over well over 50 readers, located in car wash bays and vacuums. systems have been installed close to two years now. have not had water problem s. when installing these units when to a lot of work to make sure that the factory seal made good contact with meter housing and that wires ran...

had 12 -250 watt metal halide fixtures, installed 12-Lithonia 30 leds fixture units in place of existing lights. was not looking for the cheapest way out, but the easy way out. fixtures are lighter, were easy to install, cost about $425 a fixture and don't have to worry heat in lights and those...