Search results

According to Nick at Dixmore the sensor is not a thermocouple.

So if I used two sensors, one is 4' in length, the other is 90' in length. The longer run would have more resistance thus giving it an incorrect or different reading from the sensor with the shorter run. So if the sensor was calibrated with a 50' cable and you shorten the cable the resistance...

I know it will work... Called Dixmor again, talked to Nick...His reasons not to "bug, splice or junction" the sensor wires were, possibility of a false reading caused by a short. I guess a short could happen in any junction box, anytime with low or high voltage, in commercial or residential...

By "bugged" I mean to run the sensor wires to a junction box, then run an 18/4 wire from the weep mizer to the junction box and using wire nuts "bug" them together. The sensors will be separated at the Weep Mizer. The idea would be to have the jct box in a more accessible location so that if...

Anyone ever bugged together the wire on a weep mizer sensor? I am in the process of remodeling and want to add a second sensor. It?s a belly crawl in a very tight space in the attic to reach the wires where they go into the Weep Mizer. I would like to run a #18 stranded 4 wire to a box in...

Don't know how to post a picture. The tank is 16"w, 19"h, 12" front to back, split in two, one tank for reg fb, other for affb. The float that is in it now is round, 2.5"w x 3.5"L , #16 wire. The pump is 1/2hp G&L. SFA 10/5. The 3by70 float from graingers looks like it may be smaller judging...

Need to replace the floats in a D/H AFFB system. If you know the tank I am talking about you know how small they are. Looking at these for replacements: http://www.grainger.com/Grainger/items/3BY70 But I am concerned about the footprint of the float, I am not sure how big these floats are and...

What type of float switches are used for low water cut off in liquid holding tanks? Are they N.O.? Where do you get them?

Is the Remote Bulb Thermostat on a AFFB system SPDT?

Check out Tagshot 2 at Carwashcameras.com

Anyone use break away fittings on the gun or booms?

Did you seal around the bottom of the panels after they are all up ?

See Below...

Anyone use silicone to seal the bottom of the finished FRP?

Dilling-Harris has them. Little black box about 1.5" square, I think 2 sec delay, Very simple to hook up. You can't change the delay time. I have them in all my bays.

You said this. Then you said this. Then this. PS Liquid side is 3/8? .You have no metering on the PS liquid side. You use the same ?? air line for both PS and TC, evidently you are metering the air lines on both since you don?t have metering on the PS Liquid Side. You use a higher...

What size air lines on PS & TC?

This is the problem I have, they get frustrated and switch So your setup is: FB 1/4 Air 1/4 Liquid. TC 1/4 Air 1/4 Liquid PS 1/4 Air 3/8 Liquid. Why don't you think you need the same volume for the TC as the PS? Thanks for the input, I appreciate it.:D

What size air line do you use on the Presoak?

No. None of the LP units I have from D/H have metering. When using metered solenoids is it best to have it on both air & liquid or just one or the other?