Search results

Here’s a few pics of my transformers. I’m assuming the input is on top and output is on bottom? MEP, you said to check x1 to x1 and x2 to x2 for voltage. X1 has a fuse. Does this change anything?

I’ll check the voltage on the outputs tomorrow. If I install an isolation relay do I need 1 for each bay so 4 total? Does anyone have a link for isolation relay that will work?

I may have to get an electrician to help me with this. I’m not very good with electrical. I do know like 80 said that all bays have they’re own transformer and It appears they all have a different common wire running to the different bay terminals. What’s the easiest way to make the air logic...

No spot free right now. That’ll be my next addition. I’m going to take your advice and just install a regulator coming out of the compressor and run all my low pressure functions through it!

One other question, the installation manual say air pressure going to the board should be less that 100 pounds. Mine is currently set around 140. Can I just turn the pressure down on the air compressor without it affecting the flo jets for my current low pressure functions?

Yes, I currently have several. I've got 2 offs, a tire and a wheel cleaner which is the same product, and 2 rinses. My current setup is 1. Tire cleaner 2. Wheel cleaner (same product) 3. Presoak 4. HP soap 5. Foamy brush 6. Rinse 7. HP wax 8. Rinse 9. Off 10. Off I think Id like to move the...

I’ve got a new air logic panel that’s going to be used for hot wax. Just trying to figure out how to correctly install the wiring.

I need some help on wiring a lp panel. I’ve never done this before. Attached are some picture from the wash. Do I have to do anything with the switches?

Thanks!

80, It looks from your pictures that your water supply and air supply to the LP panels are 3/8 polytube? Just curious if you get enough flow for things to work smoothy?

I’m $1 for 2:20 in the bays and $1 for 4 min on vacuums. Problem is I’ve got competitors on the other end of town that are cheaper than that. East TN

80, I think I'm gonna go with the same setup as above. It looks like everything is foaming great. Do you add any foam additive to your chemicals or is running them through a foamer enough? What tip size are you running in the gun? Also, If I remember correctly didn't you do your own programming...

Anyone ever done it? Are there any cons to doing it? Could I run all my low pressure functions through the TF gun?

Is it just regular PVC? What size? It looks very thin.

2 biz if you don't mind me asking, how did you make the caps that cover the PVC?

Greg, how does it foam? In your opinion does it perform better than wax? Would ceramic still be effective if it was dispensed at low pressure out of the hp gun?

Do you prefer the hot wax over the ceramic?

Has anyone dispensed ceramic wax out of the foam gun?

Whats your guys thoughts on triple foam vs hot wax? Has anyone tried both?

For you guys that have double booms, are they good about returning to the wall?