Search results

They are plastic rivets. You would drill new holes in the block for the new rivets?

I’m going to replace the FRP panels at the wash. For you guys that have previously done this, what is the best way? My current panels are riveted in. By looking at my panels it doesn’t appear that the rivets are evenly placed/symmetrical on each panel. Should I pull each panel off and overlay it...

I have a MEI AE 2602 U5M acceptor that's gone bad. Apparebtlyt that model has been discontinued. Anybody have any idea what a suitable replacement would be?

I’m having issues with my changer not dispensing coins. I took it the hopper apart and it appears the red conveyor has worn down over time. Am I correct in assuming that the notches on the conveyor should fit nicely into the track? Mine appear to be extremely worn down. When I opened the...

My wash is shut down due to cold weather. I stopped by today just to check on things and my flojet for the FB is periodically pulsing. Does this mean one of my solenoids is leaking or hung open?

I.B. I was thinking about the same thing. How many do you use and what’s the size of your equipment room?

Does anyone have a backup heater that doesn’t require electricity? I currently have a ng heater with an electric igniter which works fine but would be useless in the event the power goes out.

Does c3 work good on grease?

For those that use FRP in bays, what chemical do you use to clean with?

Can anybody give me some advice on drilling a plug lock out? Someone has tried to pick/pry the lock. I finally got key inserted into the lock but I’m unable to turn it.

I got my measurements and called a couple local sheet metal shops. They bent the panels for me and made end caps as well. The price was very reasonable. Given lumber costs today plus the labor to build a trough I'd say you'd come out cheaper if you went with sheet metal and have the added...

Got it! Thanks MEP, Randy and others. Couldn’t have done it without you.

Right here? The empty slot (currently not visible) under the yellow connector. Also where should I be drawing my power from for that wire? Is the bus bar ok? 10Ga?

Which one is the timer relay?

This is what I have but my vacuum will not kick on. The top wire on the terminal is my hot wire. I checked and it has 125 volts on it. The second terminal wire goes to my motors. The top coil is a common tied to the bus bar. The bottom coil is tied to the timer. Anybody see what I’m doing wrong?

Sorry guys. This is all confusing to me. Does this look right?

MEP what the easiest/correct way to connect the 10 ga wires to the mercury terminal blocks? It doesn't look like the holes are big enough to tie 2 wires together and insert them into the hole.

This may also help.

One last questions guys. Forgive me I don't have a lot of experience with electrical work. I just want to make sure I'm correct before I wire it up. Is my placement of the mercury terminal wiring correct? Also can someone tel me which 18ga black wire is the timed load?

Thanks Randy