Search results

I’m using PSI 2) I’m using a red tip 3) I don’t have a strainer and it is not clogged up 4) yes I have checked the voltage and I’m getting 24 v 5) I have turned down the flow of water 6) I and going to check the hosing going to the pump tomorrow I am also going to lower the soap tank level a...

And I haven’t solved the issue yet

They are Kip solenoids for the high pressure

@MEP001 i meant the soap is getting plenty of chemical added to it

@cantbreak80 i tried to do that and no soap is going to the gun. I know it’s getting sucked into the tank and I also see it’s going to the solenoids but for some reason not. Getting out to the gun

Sorry for the late replay. I am getting plenty of suction to the tank. I’m thinking it might be the hose plumbing I’m going to try and use the method you are talking about @cantbreak80

Yes I have voltage

I have got the foam brush and tire cleaner working, however today I ran into the high pressure soap not working. I have checked my solenoids and cleaned them out, I have also put a larger tip size in the Hydrominder but I’m currently still getting no soap to my bays

Huge update: 1) I simplified the wiring for the foam brush and it works way better 2) I found out why my fuse was blowing, the last dumb individual wired in a dosatron setup and was causing voltage to bounce back and forth on a screwed up timer

Sorry for the long wait on an update: Currently stuck: 1) bay one is currently not setting power to it and I have metered it and it’s getting power to the box however my fuse (5amp keep blowing) 2) I still don’t know what I can get rid of the in the control panel @MEP001 I’m currently hitting...

I will post updated pics as I go along

@MEP001 im planning pre building my LP set up and attach it to the top part of my soap tanks and working my way from there to start the simplifying process

Well I have a 3 bay SS that has SUPER old D/H and Coleman equipment that is rusted out to the point solenoid connectors are snapping on in the terminal connectors and instead of taking a ton of time to do a full rewired and try to chase ghost I was going to get new equipment for that one but the...

Would you recommend 18 AWG for the wiring or 20?

I appreciate it @mac and @MEP001

Well I looked at going that route but I’m too stubborn that now I’m on a mission to get the original equipment running properly

Crestview Florida. It’s a part of the panhandle and unfortunately these are the only 2 SS in the city so I’m pretty much up a salt creek

@mac unfortunately there no one even close to me that won’t charge and arm and leg

I’m also fairly new to the car wash Industry

Sorry for not replaying sooner @MEP001, the issue I’m really running into is the previous person how was running the place cut wires and change up the entire wire set up and I’m basically trying to figure out how it needs to run from the control box to the solenoids. 1st question: is it suppose...