Search results

Read the whole thread, Apw took his Monex reader out in January of this year.

Maybe Dixmor? What exactly is happening to the timers? I’ve had very good luck with the LED 7 timers.

Car Wash Equipment Transformer | Micron | B100-0585-1 (kleen-ritecorp.com) I can't tell for sure in the picture if the 24v hot wire is fused somewhere, but if definately needs to be.

Do you have a link to that power supply?

Keno, I'm a little confused, I understand about the relay and why it's needed, but thought the Nayax Vpos had two wires in the harness that powered the relay? What exactly is the power supply needed for? Only thing I can think of, is if it is on a vac that only has 120V and is needed to power...

When I had my two washes, all hydrominders had filter screens on the inlet side. Not sure why you wouldn’t have them.

I’m pretty sure coin 2 is on J9. Should be at the top of the board that shows the 4 wash prices and names.

Dosatron is jump a device that pumps chemicals from point A to point B. You need air to make that chemical foam. Most all foam brush systems I have seen have a chemical and air line ran to the brush boom in the bay, where they are tied together. If you don’t have a way to mix air with that...

Greg, just do it. I will come down and help you get them set up and take care of anything else you need done on your Istobal machine.

That metal connector is what powers both sides of the switch. Should be on 10 and 20 since it’s a 10 position switch. Also needs the timed load coming from your timer hooked to 10 or 20

What about @Buckeye Hydro

Why did you change the contactor, was it doing the same thing? A pic of the panel box showing the contactor you installed would help a lot.

Call Istobal parts department @ 800-336-8795 ext# 112 and ask to speak with Michael. They have both decals in stock. part# SIG1296 full door decal part# SIG1290 touchpad overlay How’s that @Greg Pack?😂

Worked at Magic Wand several years. Where is this wash located?

Email sent

I have the electrical schematic for the M7, if you would like that, pm me your email address.

Have you confirmed that 11 and 21 are jumped together on the switch? According to your video, only the high pressure functions are working. My question is, when you turn it to high pressure soap and the pump kicks on, does it spray soap or just water? Same thing with high pressure wax, does it...

If the bay is set for 8 coins and comes on with 5, it’s either the timer or coin mechanism. You can test that following the info in the attached photo. As far as the the functions working on the rotary switch , as long as 11 and 21 are still jumped together, you got a bad switch.

Can you tell us a little more about ruining a Nayax reader with 26.5 VAC? Did the display just go dead or did it quit sending pulses? Just curious, because after reading your post I looked at the specs of the Nayax reader and seen where the recommended incoming voltage was 12-24 VAC or 12-42...

According to the Rowe manual, the out of service light is 12vdc