Search results

Is this happening on that Chinese made machine?

Yes sir

2" is what I go by for both.

When swapping from Coleman to Dixmer you need to disconnect the ground wire from the door and terminal strip. If you dont the horn will sound and it can burn your PBC board if you have one and even the timer. Completely remove the ground and you will be good.

Why were the machines sitting in crates outside your car wash for over a year? Is your 5 million dollar tunnel Chinese made too?

Dont switch too fast. I just got a brand new commander set up and within a day of it being powered up the IDTECH reader failed.

Free enterprise is what this country runs on. As much as I hate corporate ruining mom and pops there is no one that can stop them. You just have to wait for them to go bankrupt which they all will eventually in my opinion.

The CC talk board is what you're looking for. I believe I have a few of them as well as a couple hoppers. I will check next time I'm at that site.

Not sure what razor uses for energy chain but all igus e chains snap open. You just use a small flathead to get them open. I can't imagine your energy chain can't be opened. If you know the dimensions of your old hose you can use a coupling to connect the new hose to the old one then pull the...

You're right and I completely forgot until you mentioned. I should have went into more detail. The drive forward light I hooked it up to was an entrance drive forward light not a in bay one. It was easier for me than to wire four relays for the vends. You may have to do that if you dont have...

Ive done this for a few people. One wash I used the entrance door open/close outputs to send signal and control the gate. Another wash I used the drive forward and stop light outputs to control the gate.

Also forgot to mention since your doing a touchless the penetration from your overhead spray bar will be much weaker being it’s almost 2 ft higher. So you also sacrifice wash quality. How significant it is you would have to go through one to find out.

If your two auto bays are identical size and you're running enough cars to justify a second machine I would go standard height. Who ever pulls in goes to the one with the fewer cars in line. It does not matter. If one machine is down just tap the button on your phone to shut the power to your...

Your customers will use your standard height more. They will get a better dry being that the dryers won't be 10ft off the ground to accommodate for the machine clearance height. Something to think about.

I know the exact wash you're talking about. DONT EVEN THINK ABOUT IT! That place is so f***ed up. If you want to get into detail on everything thats wrong with that place you can PM me your number and we can talk because it's way too much for me to type out.

Yup. I assume he is. If not, then rain repellent could be a good alternative.

I like the dirt buster, turbo dryer, and rain x. Good thinking.

Im in MI. I sent you a PM with my info. Im a car wash chain owner, distributor, and installer. I can help you out with the building process. I dont mind.

I will help you if you want. I will admit I dont have much of an online presence for my businesses. I do however own multiple locations including tunnels, self serves, and IBA's frictions and touchless.

Check if you have air going to your bays. If your air solenoid is not opening then yes you will put out just liquid. Air is what makes it foam, not the chemical no matter how strong you run it.