Search results

OP says it was the local health dept. Reducing Fed regs won't necessarily affect their regs. Everyplace is different.

Whatever they do would likely only apply at the Federal level and would not apply to a state or local agency.

I was advised to use single wire braid 3/8" hoses when I too over a SS because it would not kink and stop the weep as other hose might. Never looked back

I tried to schedule a monthly shot of WD 40 in all locks. Many "Lock People" do not like this but it seems to flush out junk and corrosion and keep things lubricated.

If you are mounting in block avoid anchors and bolt them thru the wall with Fender Washers or a steel plate on the other side or back to back if using 2 and the bays will accommodate that and consider using Stainless all thread, nuts and washers

If I tried to call in sick there would be no one there to answer the phone. But luckily with n 8 Bay Self Serve and 3 changers there is some redundancy.

1505 all year

If the bags are that new and motors are sucking in trash you have a bad seal around where bag is installed. or a hole in a bag allowing trash to get to motors . Otherwise that cannot happen. I would also suggest a screen below each motor but if you are bypassing trash that will get clogged...

I use the hose clamp but take a slightly larger piece of hose about 2 inches s long and slit it lengthwise and put that around the hose with the hose clamp over it. Keeps the clamp from cutting thru over time - then again if is too secure and gets hooked.....

Many different system out there so hard to advise. MIne had a separate line from the soap tank to an injector at each pump. Each line had a screen filter in the tank. When HP soap was chosen a solenoid at the tank would open allowing soap t flow to the injector. So, you could have a clogged...

MIne used the HP motor contactor since the HP Pump and Air shamee were separate choices and could not run at the same time.

No concern someone will hit that pole?

What are you using th hoe for? For SS and Prep I use the single wire HP Hose from KR. I order lengths I need with swivels and Hose saver on one end. Cost not so different than ordering bulk hose, and ends / swivels separately. IMO Hydraulic hose is too heavy and tiff. Due to varying...

Either they are dingbats or BSing you.

If the business has multiple entry points this could be quite cumbersome. (Having an inspection arch at each point.) Simplest would be a vehicle check in procedure with a diagram like they use for rental cars and perhaps digital photos of any issues.

Many Venders offer "Inspection arches" used at both the entrance and exit of the tunnel to establish whether damage was there before and or after wash. They can "See" a lot" but not everything. You could also make your own "Arch(s) to do the same thing.

Maybe you can set up your phone to record it while you turn it off and on.

Suffice it to say years ago I took over a place with 10HP blowers. They made noise but had little effect. Replaced with 15HP and at 4 locations only used 15HP

End of linked story says wash paid

Other possibilities. Bad Check Valve at bay allowing liquid to back feed thru the air line and leaking out