Search results

If you have tested the coordinator at another site and it works fine there, I don't think buying a new one is going to fix your problem. I would think that if it only happens at this particular location, it would have to be something to do with the internet connection at this site. Do you have...

I can't speak good or bad about their chemicals, since I have never seen or used them. However, I do know that Steve is no longer with Fragramatics.

I've talked to Rob several times over the years on the phone. He is for sure legit.

Assuming the chemical line runs to the boom in each bay, I would run the air the same and t it in there.

Sent you a private message

When you say you have 24v on the output side of the transformer and 24v at the timer, you have checked that with a voltmeter right? Reason I ask, just because timer lights up, doesn't mean you have full 24v there. Since you replaced the switch, if it is an 8 position switch, 11&21 have to be...

Just replaced one for a customer a couple weeks ago with the one Earl linked above. Works perfect and can't beat the price.

Pat is correct. Black floor heat tubing was run through the rail.

Etowah does have a nice system, but damn, how much more could it cost them to add a cut off valve on the discharge of the tank? Sure would make it so much easier servicing the filter, pump and solenoid bank.

That's actually a 10 port manifold with 8 ports plugged off. Istobal does have them.

Any luck finding the problem?

If I'm not mistaken, on a 12 position rotary switch, they have letters instead of numbers. L1 L2 and L3 should be jumped together with the timed load wire hooking to them. Like Greg said, hooking up another timer that you know is working, will at least eliminate it as being the problem.

If you have an 8 position rotary switch, make sure that 11 & 21 are jumpered together. If it's a 10 position, make sure 10 & 20 are jumped together. With the timer counting down, check to see if you have 24VAC between 11 & 21 to neutral or 10 & 20 to neutral. Is it possible the new rotary...

All of those machines produced at the factory were bare aluminum. Definitely not an eye catcher, but a true work horse.

Sounds like there is an issue with the mercury relay. Only other thing I would have checked, would be voltage between the second terminal down from the top of the mercury relay to ground with the timer not activated. Should be 120v, that is what is transferred to the top terminal when the...

Did you get this problem resolved?

Just being sarcastic,like I assume you were.

What kind of timer do you have? Do you have a picture of your timer? I sent you a private message this morning

How many times have you called Istobal tech support?