Search results

I got a call today that my brine tank was overflowing. Checked it out and the brine line from one of the tanks was running non stop. It was the tank that was offline, so I just bypassed it for now until I can figure out the issue. I have zero experience working on softeners and was wondering...

My lights are off during the day and the bays are very open and bright. I don't think you would even notice if the lights were on during sunlight hours. Maybe some washes are covered in shade and would benefit.

Why 24/7 on the bay lights?

Amy has been there for a while. I sold with them a couple of years ago and no issues.

I have one mounted on a vac, can't remember where I got the bracket from. Probably Fragramatics.

Thanks. Latches should be easy to move. Is the security bar just riveted in? Is that secure enough?

Just press the yellow button on your board inside, that puts it in programming mode. Then the screen will walk you through it. Cycle to prices and it tells you what to press to save or move forward etc.

Would this be better than doing a Genesis conversion?

What make diaphragm check valves special or needed? I have a few on my Tandem and G5's and was thinking of swapping them for conventional check valves. Was wondering if they served a purposed that I am not aware of? Have a few that just keep dripping. Thanks.

Door is 12 inches tall and about 16 inches wide. Latches start at 2" from top and bottom, 7" between them. Thanks!

Anyone know if the JE Adams security kit would work on a Carolina Pride round vac? If not, is there a different kit I can use? https://www.kleen-ritecorp.com/p-19628-j-e-adams-8104-security-door-kit-for-vacuums.aspx

Diskin stopped selling their model since sales were so low.

I love my Jim Coleman Pump stands, not sure what makes other so much better. Very easy to work on and very reliable. Maybe I just dont' know better?

Not sure if twice the amount is used, but them mentioned little to no dwell time was used. Petit distributer said the same thing about only one pass and no dwell. Would be great if anyone else here had some experience with it.

I agree that a touchless can only clean so well, but if you can use one pass and get the same results, that would save wash time and wear and tear on the machine.

Anyone here use Synergy Solutions for their chemicals? Met them at the show and they were pushing their single step polymer presoak. Met a Petit distributer that says it's all he uses and it works well. Only does 1 pass using it with the Petits.

Agree with lots of what you said. Nayax was everywhere at that show and looked great. Cryptopay one time use cards cost $1 each regardless of how many you purchase, but you have to get them in packs of at least 100. I'd rather give out MEI coupons and I get those back. Unitec machines are...

Mine were installed 8 years ago, you would need to find your nearest distributer and have them quote it.

I have 2 and love them. My question is just if one that was tied to a tunnel and is with the DRB division would work with an IBA.

I am discussing the purchase of used Unitec Portal Ti. It was used in a tunnel wash and is connected to the DRB tunnel division from what I was told. Does anyone here know if I would be able to use it for an IBA without having to modify anything or purchase any different software? Thanks.