Search results

After all the talk about the blue and grey foot valve’s thread I called tech support at hydro. I was told that the discharge tube (11) should be above the highest level in the tank, in the instructions it says that “to prevent foaming, be certain that the solution level will always be above the...

I had a problem with economy check valves from KR, they were constantly separating where they were pressed together, I called KR and they said they got a bad batch from the manufacture and they replaced a dozen and it fixed the problem. Like Randy says should call if you having a problem, if no...

Type in pipe screen's on ebay, they look close to the same size. You can get 20 for like a $1.00.

where do you get these?

How often should a single 4x40 RO membrane be set to backwash?

I don't think that there is a difference between the membranes, the pressure should be able to be adjusted on your RO setup, there should be a balanced pressure regulator or something like it that you can adjust the pressure.

I have a single 4x40 ro membrane. What should the pre and post membrane pressure be. I just replaced one and it is 120 psi in and out. Does that sound about right?

Would you spend the extra $ for an ASME boiler storage tank?

Warsaw Chemical sells it cheaper than KR.

Just a note that on the SB3 these pass through as a quarter not a token.

I found this with a further google search after the post: http://boards.straightdope.com/sdmb/showthread.php?t=710112

I see these are selling on ebay for around $15.00 ea. Looks like I may have actually made a profit at the wash today.

Pulled these from the coin box today. They look exactly like a quarter, I kept looking at them and because they wouldn't go through the coin counter, then when you look closer you can see why.They are slightly larger than a quarter which makes sense, but I thought it was illegal to make a token...

Anoyone know if the ginsan boom spring sold at KR will fit D/H double boom's? When we purchased our equipment in '94 they were together as one co.

Are you running this to a holding tank? Also it looks like it can be sidewall vented.

Using a second nut on the face seem's like it would be defeating the purpose of having the boot as water could still get in where you don't want it to, i would just use the boot and a nut an the inside, and tighten good, I never went crazy to tighten the nuts behind and on the front of the...

I'm not expert on compressors, but i just purchased a: http://www.aircompressorsdirect.com/Schrader-SA1526-Air-Compressor/p8159.html for my garage, you may want to check with the manufacture of your IBA to see what they recommend for CFM, but i know if i was in a pinch i could use this...

I posted this for newbies who may be searching the forum for an answer, just so it is out there. I love this forum, have been doing this for almost 30 years, but i learn something every day.

thats never going to happen, i'm not being sarcastic, but we are not the only ones looking.

Is this just with the tm6 timers, cause I tried it with dixmor and it did nothing. I would maybe be careful what u say, maybe pm someone who may have the answer.